Product Information: As an upgrade of the original iTaste MVP the iTaste MVP V2.0 has substantial improvements in both appearance and function. Variable Voltage: voltage can be adjusted from 3.3 – 5.0 volts in .1 volt increments. VariableWattage: Wattage can be adjusted from 6.0 – 11.0 W in .5 watts increments. Ohmsmeter: Reads resistance of your atomizer/cartomizer/clearomizer. Battery Level Indicator: The iTaste MVP2.0 battery capacity is displayed via green, yellow and red LED lights. Green = Fully Charged When the iTaste MVP2.0 is fully charged the LED light will turn green and power off. Yellow = Half Discharged Red = In need of charging Puff Counter Short Circuit/Atomizer Protection. Over-Discharge Protection. Battery Level Indicator Large battery capacity: iTaste MVP e-cigarette built-in 2600 mAh polymer Li-Ion rechargeable battery. High compatibility 510 connector: Thread fit iClear10,iClear16 ,iClear30 etc. ON/OFF battery switch: 10 seconds cutoff. Passthrough / Vape While Charging Technology. Remembers last set voltage or wattage: Remembers last set voltage or wattage when the battery is turned off and then back on. Built-in 3 digit display: Digital display shows Ohms meter, Voltage /Wattage setting, number of puffs taken since last time the battery was turned off. Portable power source for electronic products.

To create the ultimate vaping device the teams at Innokin and Evolv have worked together closely over the past 8 months and have created a revolution in vaping that is also destined to be a milestone in vaping history. We have created the iTaste SVD2.0. The iTaste SVD2.0 is a device that is powerful and beautiful, ultra-intelligent and also priced perfectly. The SVD2.0 is the first and only Advanced Personal Vaporizer to run on the powerful and precise Evolv DNA Experience microchip. Designed and manufactured in the Unites States by Evolv, the patented DNA Experience microchip offers true power control and unrivaled consistency. Technical Specifications: Input Voltage: 3.2~4.3V Output Voltage: 2.0~6.3V Maximum Output Current：6.0A Maximum Output Wattage：5.0‐20W Resistance of clearomizer：0.5 ‐3.0 ohm (0.5 Ohm minimum) Battery: IMR high drain 18350/18650 (without protection, maximum current> 5000mA.) The iTaste SVD2.0 cannot use 2 stacked batteries and any other types of batteries may damage your iTaste SVD2.0. Features: Variable Wattage: Wattage can be adjusted from 5.0 – 20.0W in .1 watts increments by pressing “+” and “‐” button. Lock the selected Wattage (Hold both the "+" and "‐" buttons for five seconds) After setting your wattage you can lock the setting to prevent accidental changes to your wattage. Press and hold both the + and ‐ buttons for five seconds to lock your settings. The screen will show “POWER LOCKED HOLD UP DOWN “ and current setting parameter of wattage ,Press and hold the "+" and "‐" button for five seconds a second time to unlock. Please note that all other functions (such as ohm check and battery check) are still functional while you have the wattage settings locked. Short Circuit/Atomizer Protection (0.5 Ohm). Battery Checker. Overheat Protection. Reverse Polarity Protection.

The iTaste VV4 is the newest in the line of bestselling Innokin Technology iTaste VV vaporizers and features a wider range of Variable Voltage, Variable Wattage, advanced safety features and also ‘Vape while charging’ Technology. The Primary Features of The iTaste VV4 Battery Level Indicator: The iTaste VV4 battery capacity is displayed via green, yellow and red LED lights. Green = Almost fully Charged. When the iTaste VV4 is fully recharged the LED light will power off. Yellow = Half Power. Red = Low Power. Charge the VV4. Variable Voltage: Voltage can be adjusted from 3.0 – 6.0 volts in .1 volt increments. Variable Wattage: Wattage can be adjusted from 6.0 – 15.0 Watts in .5 watts increments. Large battery capacity: The iTaste VV4 has a built-in 1000 mAh polymer Li-Ion rechargeable battery. ON/OFF battery switch: Press the power button three times in rapid succession to turn on the iTaste VV4. Once the iTaste VV4 is On hold down the power button to activate the atomizer and vape. When the iTaste VV4 is not in use, press the power button three times in succession to power off the iTaste VV4 Advanced Personal Vaporizer. Always power off the iTaste VV4 Advanced Personal Vaporizer when it is not being used, or when it is going to be stored in a pocket, bag or purse. SAFETY: 10 second cutoff: If the activation button is held for 10 seconds or longer the iTaste VV4 Advanced Personal Vaporizer will stop firing until the button is released and pressed again. Low Voltage Warning: The Red LED and Battery bar will continue blinking when the battery capacity is lower than 3.3V and the iTaste VV4 Advanced Personal Vaporizer will power off automatically. Short Circuit/Atomizer Protection: Short Circuit/Atomizer Protection protects the iTaste VV4 Advanced Personal Vaporizer against shorted atomizers and will stop the unit from functioning in unsafe conditions. The iTaste VV4 features automatic real-time atomizer Ohms detection. If the resistance of the atomizer is lower than 0.8 the Ohms bar will blink. If there is a short circuit the VV4 screen will display the following and the LED light will power off. Over-Discharge Protection: The iTaste VV4 Advanced Personal Vaporizer monitors the battery voltage and will automatically power off when the battery is discharged. High compatibility 510/ego connector: Threads are compatible with the following clearomizers: iClear16, iClear16B, iClear16D, iClear30, iClear30B, iClear30s, iClearX.I. Gladius and other standard 510 threading. Technical Specifications: Variable Voltage: Voltage can be adjusted from 3.0 – 6.0 volts in .1 volt increments. Variable Wattage: Wattage can be adjusted from 6.0 – 15.0 Watts in .5 watts increments. Standby current: 50uA max Maximum output current：4.0A Charging: Micro USB DC5.0V/500mA Short Circuit Protection: 0.8 Ohm

Product Information: Short Circuit/Atomizer Protection: Short Circuit/Atomizer Protection protects the iTaste EP against shorted atomizers, and will stop the unit from functioning in unsafe conditions. Over-Discharge Protection: The iTaste EP monitors the battery voltage and will automatically turn off when the battery is discharged. Battery Level Indicator: The iTaste EP battery capacity is displayed via green, yellow and red LED lights. Green = Fully Charged When the iTaste EP is fully charged the LED light will turn green and power off. Yellow = Half Discharged Red = In need of charging Large battery capacity: The ITaste EP e-cigarette has a built-in 650 mAh polymer Li-Ion rechargeable battery. The ITaste EP e-cigarette has a built-in 650 mAh polymer Li-Ion rechargeable battery. ON/OFF battery switch: Quickly clicking three times will enable the iTaste EP for normal function. Once enabled, holding down the button will activate the unit to power the atomizer. Disabling the iTaste EP stops the atomizer from turning on while stored in your pocket or bag. 10 seconds cutoff: If the activation button is held for 10 seconds or longer, the iTaste EP will stop activating until the button is pressed again.